Inserting Batteries; Preparing The Aircraft Powered Headset For Use; Attaching And Removing The Cable - Bose Aviation Headset X Owner's Manual

Getting Your Headset Ready for Use
Figure 10
Installing the two batteries

Preparing the aircraft powered headset for use

14

Inserting batteries

Insert the two supplied alkaline AA batteries (IEC LR6) into the
control module (Figure 10).
+
CAUTION: The battery compartment is designed to prevent inad-
vertent reverse polarity from installing the batteries incorrectly. If the
batteries do not seem to fit correctly, do not force them in. Forcing an
improper connection will cause permanent damage to the control
module.
For an aircraft powered headset, the cable is permanently installed in
the aircraft.
CAUTION: The aircraft panel connector must be mounted by a
mechanic qualified to perform this type of avionics installation for the
aircraft you are using.
If yours is an aircraft powered headset, there is a connector on a 6-
foot wiring harness that came in the carton. This self-latching, preci-
sion designed quick-connector is designed for panel mounting and
mechanically keyed to ensure proper mating.

Attaching and removing the cable

When the quick-connector is installed, the cable leading from the
control module connects to it. Match the narrow bar on the cable
end to the slot on the connector. Press in until the two parts engage
(Figure 11 on page 15).
To release the cable, pull back on the sleeve near the end of the
cable. Then gently remove the cable from the connector.
AM270261_00 V.pdf May 16 2003