Connect; Connect The Telephone Base; Connect The Charger; Mount The Telephone Base - VTech CS6120-2 User Manual

Connect

You can choose to connect the telephone
base for desktop usage or wall mounting.
NOTES
• Use only the adapters provided.
• Make sure the electrical outlets are not
controlled by wall switches.
• The adapters are intended to be correctly
oriented in a vertical or floor mount position.
The prongs are not designed to hold the
plug in place if it is plugged into a ceiling,
under-the-table or cabinet outlet.
TIP
• If you subscribe to digital subscriber line
(DSL) high-speed Internet service through
your telephone line, make sure you install
a DSL filter (not included) between the
telephone line cord and telephone wall jack.
Contact your DSL service provider for more
information.

Connect the telephone base

Connect the charger

Mount the telephone base

Install and charge the battery

Install the battery
Install the battery as shown below.
NOTES
• Use only supplied battery.
• Charge the battery provided with this
product only in accordance with the
instructions and limitations specified in this
manual.
• If the handset will not be used for a long
time, disconnect and remove the battery to
prevent possible leakage.
4
Charge the battery
Place the handset in the telephone base or
the charger to charge.
Once you have installed the battery, the
handset LCD display indicates the battery
status (see the following table).
NOTES
• For best performance, keep the handset in
the telephone base or charger when not in
use.
• The battery is fully charged after 16 hours of
continuous charging.
• If you place the handset in the telephone
base or the charger without plugging in the
battery, the screen displays No battery.
THIS SIDE UP
Battery Battery
Action
indicators status
The screen The battery Charge
is blank, or has no or without
displays Put in very little interruption
charger and charge. The (at least 30
flashes. handset minutes).
cannot be
used.
The screen The battery Charge
displays has enough without
charge to be interruption
Low battery
used for a (about 30
and flashes.
short time. minutes).
The screen The battery To keep
displays is charged. the battery
HANDSET X. charged,
place it in the
telephone
base or
charger when
not in use.
When the battery is fully charged, you can
expect the following performance:
Operating
Operation
time
While in use (talking*) Seven hours
While not in use (standby**) Five days
* Operating times vary depending on your
actual use and the age of the battery.
** Handset is not charging nor in use.
5