Connecting The Power Cord; Choosing An Fm Antenna - Bose Acoustic Wave music system Owner's Manual

Bose acoustic wave music system: owners guide
Hide thumbs Also See for Acoustic Wave music system:
Table of Contents

Advertisement

WARNING: Mishandling the remote control battery may cause a fire or
chemical burn. Keep the battery away from children.
Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate
the battery. Dispose of the used battery promptly and responsibly.
Replace only with a lithium CR2032 or DL2032 battery by Duracell,
Eveready, Hitachi, Maxell, or Toshiba (available from most electronics
stores). Other batteries are not UL approved and may cause a fire or
explosion.
For more information, call the customer service number inside the back
cover of this guide.

Connecting the power cord

1. Plug the small end of the power cord into the power jack on the back of
your Acoustic Wave
2. Plug the other end of the power cord into an AC power (mains) outlet.
Figure 3
Connecting the power
cord at the rear panel

Choosing an FM antenna

The system has an FM ANTENNA SELECT switch located on the back of
the unit (Figure 4). The switch should be in the right hand position to select
the telescoping antenna. You may choose to connect an external FM
antenna, if needed, to the EXTERNAL 75 OHM antenna jack. To use an
external FM antenna, slide the switch to the left hand position.
Figure 4
The FM antenna
selection switch
Switch position to select
the external antenna
AM253543_03_V.PDF
Setting Up Your Acoustic Wave
®
music system (Figure 3).
FM ANTENNA SELECT
EXTERNAL
75 OHM
October 16, 2001
®
Music System
Switch position to select
the telescoping antenna
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Acoustic wave cd3000

Table of Contents