Closing The Unit - Bosch NDN-498V03-21P Installation And Operation Manual

FlexiDome2X IP Camera
4.
5.
6.
7.
8.
5.3.2

Closing the unit

When the camera position is set and all adjustments have been
made, close the unit.
1.
2.
3.
4.
5.
6.
Bosch Security Systems
Readjust the focal length if necessary.
Repeat these two adjustments until the desired view is in
focus.
Tighten both screws.
Use the up/down navigation buttons to move to Exit and
press the center button until the menu disappears.
Remove the adjustment cap from the lens.
If necessary, remove the monitor cable (S1460) from the
monitor jack socket.
Place the inner liner in position aligning its fin with the
bracket on the base.
Place the dome onto the base and rotate until it clips into
place. (If necessary, clean its surface with a soft cloth.)
Place the sealing ring and the trim ring over the dome.
Align the tamper-resistant screws in the trim ring with the
threaded ends in the mounting base.
Use the supplied special screwdriver bit to tighten the
three tamper-resistant screws.
Installation and Operation Manual
Installation | en
AR18-10-B006 | v1.1 | 2010.06
37