Interfaces; Alarm Input; Relay - Bosch NDN-498V03-21P Installation And Operation Manual

FlexiDome2X IP Camera
9.9

Interfaces

Interfaces
>
>
9.9.1

Alarm input

Configure the alarm triggers for the camera.
Select N.C. (Normally Closed) if the alarm is to be triggered by
closing the contact.
Select N.O. (Normally Open) if the alarm is to be triggered by
opening the contact.
Name
Enter a name for the alarm input. This is then displayed below
the icon for the alarm input on the LIVEPAGE (if configured).
Action
Select the camera mode to switch to when alarm input 1 is
triggered. See Section 9.8.8 Alarm Task Editor, page 100, for
information on alarm actions based on alarm inputs.
9.9.2

Relay

Configure the switching behavior of the relay output.
Select different events that automatically activate an output.
For example, turn on a floodlight by triggering a motion alarm
and then turn the light off again when the alarm has stopped.
Idle state
Select Open for the relay to operate as an N.O. contact, or
select Closed if the relay is to operate as an N.C. contact.
Select
Select External device or Motion+/IVA to trigger the relay.
Relay name
The relay can be assigned a name here. The name is shown on
the button next to Trigger relay. The LIVEPAGE can also be
configured to display the name next to the relay icon.
Bosch Security Systems
Alarm input
Relay
Installation and Operation Manual
Advanced Mode | en 101
AR18-10-B006 | v1.1 | 2010.06