Leveling The Dishwasher; Securing The Dishwasher - Bosch SRV53C13UC Use And Care Manual

Figure 16
Top Mount
Figure 17
Figure 18
Figure 19
12
Dishwasher Placement
SLIDING THE DISHWASHER INTO PLACE
The unit should now be ready to slide into the cabinet
opening. To avoid scratching the floor, use floor protection
and caution when sliding the dishwasher into the cabinet.
Make sure that the hoses and cords do not bunch up
behind the unit or kink as you slide the unit back. Make
certain to slide the unit into place before raising the leg
levelers.

LEVELING THE DISHWASHER

Make sure the dishwasher is level. Adjust the rear leveler
by turning the center screw at the front of the dishwasher,
as shown in Figure 16. Turning the screw clockwise raises
the rear of the dishwasher. Adjust the front levelers as
shown in Figure 16. Turning the levelers to the right raises
the dishwasher.

SECURING THE DISHWASHER

1. Drive the mounting screws through the holes in the
Side Mount
2. After the unit is installed in the enclosure, leveled and
3. Tighten screws until they are flush with the surface of
ATTACHING THE TOE PANEL
Your dishwasher comes with a two-piece toe panel to
allow height adjustment.
1. Position the slotted rear toe panel on the dishwasher
2. Position the mating front toe panel on top of the rear
3. Drive the two black screws (included) through the hole
mounting brackets as shown in Figure 17 for Top or
Side Mount.
secured, lock the two front leg levelers in place by
driving the enclosed leg leveler locking screws into
each screw boss located in front of the levelers. See
Figure 18.
the bosses.
first. Allow it to rest on the floor.
toe panel allowing the angled edge to rest on the
mating edge of the dishwasher.
in the toe panel to secure. Use the supplied screws to
avoid damaging the dishwasher. See Figure 19.