Using Your Steam Mop - Shark Pro Steam Pocket SE450 Series Owner's Manual

GETTING STARTED - CONT'D
fig. 2
fig. 3
2 Use the lavender loop on the side of
the pocket pad to slide mop head into
pocket. Then secure the quick fasteners
on the top of the pocket to lock in place.
(fig. 2)
3 Insert the mop head post into the mop
body until it clicks into place. (fig. 3)
4 Twist the cap on the water tank
counterclockwise to open. (fig. 4) Use
the filling flask to pour water into the
tank. DO NOT overfill. Replace the cap
on the water tank and turn it clockwise
to secure it. (fig. 5)
NOTE: To prolong the life of your Steam
Mop, we recommend using distilled water.
8 8 s h a r kc l e a n . c o m s h a r kc l e a n . c o m
fig. 4
fig. 5
IMPORTANT: DO NOT use Steam Mop on
unsealed wood or unglazed ceramic floors.
On surfaces that have been treated with
wax or some unwaxed floors, the sheen
may be removed by the heat and steam
action. Test an isolated area of the surface
to be cleaned before proceeding, and
follow the use and care instructions from the
floor manufacturer.

USING YOUR STEAM MOP

fig. 6
IMPORTANT: NEVER use the Steam
Mop unless there is water in the tank
and a pocket pad is attached.
Sweep or vacuum your floors prior
to cleaning with your Steam Mop.
Visit sharkaccessories.com for other great
cleaning products.
fig. 7
1 Pull and twist the quick release cord
holder to unwrap the power cord
completely. Plug into an electrical
outlet. (fig. 6)
2 When cord is plugged in, the Steam
Control button will flash blue. If the
light does not illuminate, reference
the Troubleshooting section. (fig. 7)
s h a r kc l e a n . c o m s h a r kc l e a n . c o m 9 9