Entone v4 Series Manual

Entone v4.x (Black, Peanut-Shaped) Remote Control
This model has three different mode keys ("STB", "TV", or "AUX") so you can program the URC re-
mote to control one TV or one AUX device.
For point two just have to follow this instructions in the right order:
1.
Turn on your TV or your A/V device;
2.
On the remote control, press a device mode key (i.e., "TV" or "AUX") and hold for 5 seconds. The device
mode key will light up;
3.
Press the "Power" key once;
4.
Aim the remote control at the device. Press either the "CH +" key (to start searching from the lowest device
code to the highest at approximately 5 second intervals) or "CH -" key (to start searching from the highest
device code to the lowest at approximately 5 second intervals) to start device auto-scan. The "TV" or "AUX"
mode key will be on and blink every 5 seconds while in the device scan mode;
5.
If the device turns o ff, a working code has been found;
6.
Press "OK" once to lock in the code. The selected mode key will blink twice;
7.
If all code sets for that device are exhausted in the search and the "OK" is not pressed, the selected device
key will blink rapidly 7 times and the search mode will be terminated.
NOTE: During the auto-scan, if no key is pressed within 30 seconds, the device mode key backlight will blink rapidly 7
times and then stop - indicating an error.
When pressed, the selected mode key will light up confirming your choice. Then
you can use the URC to control your STB, TV or AUX device.
You have to program the URC to know what TV and AUX devices you are using by
either:
1.
Introducing the 4-digit device code;
2.
Auto search.
For point one you have to check the full list on the manual (URC4 EMEA Re-
mote Control Guide PDF). If your device does not respond to the remote con-
trol after
trying all device codes listed for you brand, or if your brand is
not listed skip to point two.
For point one you have to check the full list on the manual (URC4 EMEA Re-
mote Control Guide PDF). If your device does not respond to the remote con-
trol after trying all device codes listed for you brand, or if your brand is
not listed skip to point two