Advertisement
REMOTE CONTROL PROGRAMMING
Must set WALL DETECT RIGHT first. Failure to do this may result in poor performance of Wall
Mount. If set LEFT WALL DETECT, please use the SETUP / RESET to clear memory
SETUP:
Push / Collapse the Wall Mount Flat against
the Wall, Press and Hold for 5 seconds to
set the home position (note: this also clears
all memorized commands)
RESET: Hold for 5 seconds to clear all
commands and memorize HOME position.
STEP 2
WALL DETECT LEFT
Swivel to the closest to the
Wall without the TV
touching the Wall, leave
about 1" (25mm) of space
recommended, Hold down
Wall Detect for 5 seconds
till LED LIGHT color turns
solid
LEFT SWIVEL
MEMORY 1:
Hold for 5 Seconds until
LED LIGHT color turns
sold, memory is set
Move to another desired
location and repeat above
step to memorize again.
Power Loss or interruption DOES NOT delete or clear the memory. User
If Swivel too far RIGHT or LEFT and hits / makes contact with the wall, the
ATTENTION!
ATTENTION!
must use the SETUP / RESET button to clear memory.
unit will Stop after 2 seconds.
(English)
LED LIGHT
Flashing LED: Transmitting Signal
Solid Color LED: Memory Set or Cancelled
TILT UP
TILT DOWN
8
STEP 1
WALL DETECT RIGHT
Swivel to the closest to the
Wall without the TV
touching the Wall, leave
about 1" (25mm) of space
recommended, Hold down
Wall Detect for 5 seconds
till LED LIGHT color turns
solid
RIGHT SWIVEL
MEMORY 2:
Hold for 5 Seconds until
LED LIGHT color turns
sold, memory is set
Move to another desired
location and repeat above
step to memorize again.
HOME
This will bring the wall
mount back to the wall of
HOME position that user
setup, if user needs to set
a different Home position,
please refer to SETUP
button above for details.
P31
Advertisement
