Brother DCP-8065DN User Manual page 72

Error Message Cause
The drum unit is near the end of its
Drum Near End
life.
The drum counter was not reset
when a new drum was installed.
The duplex tray is not installed
Duplex
properly.
Disabled
(DCP-8065DN only)
The primary corona wire on the
Dust on Drum
drum unit needs to be cleaned.
The temperature of fuser unit does
Fuser Error
not rise at a specified temperature
within specified time.
The fuser unit is too hot.
The machine is out of paper or
No Paper
paper is not properly loaded in the
paper tray.
The paper tray is not completely
No Tray
closed.
The machine's memory is full.
Out of Memory
The paper is jammed in the back of
Paper Jam
the machine.
Back
The paper is jammed in the duplex
Paper Jam
tray.
Duplex
The paper is jammed inside the
Paper Jam
machine.
Inside
The paper is jammed in the MP tray
Paper Jam
of the machine.
MPTray
60
Action
Use the drum unit until you have a print quality
problem; then replace the drum unit with a new
one.
See
Replacing the drum unit (DR-520) on page 76
1. Open the front cover, and then press
Clear/Back.
2. Press 1 to reset.
Remove the duplex tray and install it again.
Clean the primary corona wire on the drum unit.
(See Cleaning the corona wire on page 71.)
Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine for
15 minutes with the power on.
Do one of the following:
Refill the paper in the paper tray or MP tray.
Remove the paper and load it again.
Close the paper tray properly.
Copy operation in progress
Do one of the following:
Press Start to copy the scanned pages.
Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Printing operation in process
Do one of the following:
Reduce print resolution. (See Advanced tab
in the Software User's Guide on the
CD-ROM.)
Clear the data from the memory by pressing
Job cancel.
(See Paper jams on page 63.)
(See Paper jams on page 63.)
(See Paper jams on page 63.)
(See Paper jams on page 63.)