Toro 105-1678 Installation Instructions page 2

3
Installing the Cable Heat
Shield
For Models 74240 and 74241
Parts needed for this procedure:
1 Cable heat shield
1 Bolt (1/4 x 3/4 inch)
1 Locknut (1/4 inch)
Procedure
1. Remove the bolt below the cable bracket that is
installed to the engine
2. Install the cable heat shield below the cable
bracket using the bolt removed in step
1).
Ensure that you install the cable heat shield
between the muffler and cable bracket.
3. Install the bolt (1/4 x 3/4 inch) in the top of the
cable bracket and into the cable heat shield
(Figure 1).
4. Secure the bolt (1/4 x 3/4 inch) using the locknut
(1/4 inch) as shown in
(Figure 1).
1 (Figure
Figure 1.
1. Cable heat shield
(installed)
2. Cable bracket
3. Cable
4. Bolt below the cable
bracket
2
Figure 1
5. Bolt (1/4 x 3/4 inch)
6. Locknut (1/4 inch)
7. Engine
g006626