Installation Steps; Installing The I/O Shield - Intel D865GBF Quick Reference

•
Up to four 184-pin Double Data Rate (DDR) SDRAM Dual Inline Memory
Module (DIMM) connectors with gold-plated contacts.
•
Support for:

Unbuffered, non-registered single or double-sided DIMMs

Serial Presence Detect (SPD) memory only

Support for Suspend to RAM (STR), S3 ACPI state

Non-ECC RAM

2.5 V memory
NOTES
System Resources (such as PCI and AGP) require physical memory
address locations that reduce available memory addresses above 3 GB.
This may result in less than 4 GB of memory being available to the
operating system and applications.
All memory components and DIMMs used with the desktop board must
comply with the PC SDRAM specifications. These include the PC
SDRAM Specification (memory component specific) and the PC
Unbuffered DIMM Specification. To view or download these
specifications, refer to this Intel World Wide Web site:
http://developer.intel.com/technology/memory/pcsdram/spec/
For information about vendors that support these memory requirements,
refer to the Desktop Board D865GBF/D865GLC link on this Intel World
Wide Web site:
http://support.intel.com/support/motherboards/desktop/

Installation Steps

1.

Installing the I/O Shield

The board comes with an I/O shield that is used to block radio frequency
transmissions, necessary to pass emissions (EMI) certification testing, protect
internal components from dust and foreign objects, and promote correct airflow
within the chassis.
Intel Desktop Board D865GBF/D865GLC Quick Reference 7