Table of Contents
Advertisement
Installation
Remove the equipment
1.
from the cabinet, which
includes the tap tower,
tower base, drip tray and
grate, spirit bottle holders
(quantity 3), and a bag of
hardware.
Install the thumbscrews to
2.
the tower base. Snap the
pads to each end of the
thumbscrews.
3.
Install the tap tower to the
tower base by threading
the drink hose through the
access hole and bolting
the large washer to the
underside of the base and
tower with #8 screws,
nuts, and lock washers
(quantity 4 each).
4.
Route the hose along the
edge of the tower base,
which requires threading
the hose past the lateral
support on the underside
of the tower base.
Slide the rubber spacers over
5.
the end of each thumbscrew.
Clamp the tap tower
6.
and base to the table or
countertop. Verify the
hose is not pinched. The
rubber spacers can be
removed in order to
mount to a thicker
countertop.
7.
Install the drip tray and
grate.
Close the tap faucet by
8.
pushing the handle away
from you.
9.
On the base cabinet, remove
the side access panel by
removing two screws and
lifting up and off. Remove
the front door by lifting up
and off.
Pull the spirits reservoir
10.
drawer out by cutting the
cable tie securing it to the
cabinet. Remove the pump
cover by removing four red
thumbscrews.
Connect the drink hose from
11.
the tap tower to the base
cabinet and secure with a
hose clamp.
For servicing and
12.
maintenance, the CO
should be able to be turned
off to the cabinet. When
running a CO
line to the
2
cabinet, include a shutoff
valve.
The unit comes assembled with a 1/4-inch male
quick coupler. The CO
matching female coupler (such as McMaster-
Carr part #6536K38), or the male quick coupler
can be replaced with a 1/4-inch barbed fitting,
included in the bag of hardware, and the supply
line is attached with a hose clamp.
Do not hook up the CO
instructed in the Sanitizing section.
Sanitize the unit as described in Sanitizing on
13.
page 6.
14.
Check for leaks in the hoses
and fittings and tighten
where needed. Verify hoses
are not pinched inside
the cabinet. Verify the
supply line CO
pressure
2
to the cabinet is between
50 and 60 psi. Adjust the
unit regulator to 30 psi by
pulling out the knob and
rotating until the needle indicates 30 psi. Push
the regulator knob in until it "clicks" to prevent
tampering, and install the pump cover.
Install the bottle holders to
15.
the spirits reservoir with
thumbscrews, and tighten with
the bottle holders in the tallest
position.
Remove the cap to the spirit
16.
bottle and slide a bottle nozzle
over the bottle.
2
supply line can use the
2
supply line until
2
5
Advertisement
Table of Contents
