Table of Contents
Advertisement
The METRA GPC cleaning:
The METRA GPC cleaning should be done during operation. Ensure tension of grading mesh is preventing sagging or
excessive tension. Check and carry out timely replacement of lubricant. Monitor the status of the grading mesh, gears and
bearings.
Caution! All work on the METRA GPC cleaning should be carried out only after having
The METRA GPC cleaning should be performed regularly, depending on the pollution, but not less than once every three
days.
1.
De-energize the METRA GPC.
2. Remove dust and mud deposits from the housing unit.
3. Remove dirt from the protective surfaces.
4. Remove all the protective surfaces in order to remove dirt from the chain and gears.
5. Remove all dirt from the grading mesh.
6. Make sure that nothing interferes with the rotation of the grading mesh.
7.
Install protective surface.
Before transferring the METRA GPC to storage or preservation, it is necessary to perform the METRA GPC cleaning,
check the fastening reliability of the moving parts, assembly mechanisms and carry out tightening, if necessary.
When withdrawing the METRA GPC from storage and preservation, it is necessary to remove dust and dirt deposits
using a soft cloth, check the smoothness of the rotation calibration mesh, if necessary, to carry out maintenance of
the motor.
The METRA GPC can be transported by any mode of transport, according to the shipping rules.
Placing and securing of cargo is carried out in accordance with the current technical rules of cargo loading and securing.
Loading and unloading of the METRA GPC is performed in two ways: either by forklift or crane.
When transporting the METRA GPC in covered vehicles, transportation without shipping packaging or with partial packaging
which provides protection against mechanical damage is allowed.
10. MAINTENANCE
verified that the equipment is de-energized.
11. TRANSPORTATION
10
Advertisement
Table of Contents
