Remove And Install Starter Motor - Yanmar BY Series Service Manual

Remove and Install Starter Motor

12/05
REMOVE AND INSTALL
STARTER MOTOR
1. Disconnect the battery negative (-) cable and
turn the battery master switch to OFF (if
equipped).
2. Remove intake manifold. See Intake Manifold
on page 5-66.
3. Disconnect positive (+) cable (Figure 10-2, (1))
and primary wire (Figure 10-2, (2)).
Figure 10-2
Figure 10-2
4. Remove bolts (Figure 10-3, (1)) securing the
starter motor to the flywheel housing.
Figure 10-3
( 1 )
Figure 10-3
BY Service Manual
5. Carefully remove the starter motor. NOTICE:
6. Clean the starter mounting area of the flywheel
7. Install the starter motor.
8. Clean the cable connections.
9. Connect the positive (+) cable and primary wire
10. Install intake manifold. See Intake Manifold on
11. Connect the battery negative (-) cable and
( 1 )
( 2 )
12. Operate starter to verify operation.
0003840
0006653
© 2009 Yanmar Marine International
STARTER MOTOR
Check the starter pinion for damage. If the
starter pinion is damaged, the flywheel ring
gear must also be checked for damage.
housing.
to the appropriate terminals of the starter.
page 5-66.
return the master switch (if equipped) to the ON
position.
10-5