Lennox VRF V22B Series Installation Instruction page 18

Network Address and Commissioning
After the system has been installed, each indoor unit must
be assigned an address as part of the commissioning
procedure.
Spot Check Instructions
Use the Spot Check Performance tables below and the
Manual button on the unit receiver to view diagnostic
information the indoor unit.
No.
0
1
2
3
4
5
6
7
8
9
10
11
12
13
This Spot Check Performance table is located on the unit service panel.
The diagnostic information can also be obtained using the wired remote controller.
Table 4. Spot Check Performance Identification Table
Content
Normal display
Communication address of indoor unit
Indoor unit capacity (horsepower)
Network address of indoor unit
The actual setpoint temperature
The actual indoor temperature T1
The middle coil temperature T2
The coil inlet temperature T2A
The coil outlet temperature T2B
The actual superheat temperature
The actual subcool temperature
Error Code
Indoor software version
End (--)
Recorded Value/Date
18