LG HB620 Service Manual page 51

3. TECHNICAL BRIEF
3.7.11 Serial Bus Interface(SBI)
The MSM6280 device's SSBI is designed specifically to be a quick, low pin count control protocol for
QUALCOMM's RTR6275 and PM6650 ASICs. Using the SSBI, the RTR6275 and PM6650 devices
can be configured for different operating modes and for minimum power consumption, extending
battery life in Standby mode. The SSBI also controls DC baseband offset errors.
3.7.12 Wideband CODEC
The MSM6280 device integrates a wideband voice/audio CODEC into the mobile station modem
(MSM). The CODEC supports two differential microphone inputs, one differential earphone output, one
single-ended earphone output, and a differential analog auxiliary interface.
The CODEC integrates the microphone and earphone amplifiers into the MSM6280 device, reducing
the external component count to just a few passive components. The microphone (Tx) audio path
consists of a two-stage amplifier with the gain of the second stage set interally. The Rx/Tx paths are
designed to meet the ITU-G.712 requirements for digital transmission systems.
3.7.13 Vocoder Subsystem
The MSM6280 device's QDSP4000 supports AMR,FR,EFR and HR. In addition, the QDSP4000 has
modules to support the following audio functions: DTMF tone generation, DTMF tone detection, Tx/Rx
volume controls, Tx/Rx automatic gain control (AGC), Rx Automatic Volume Control(AVC), EarSeal
Echo Canceller (ESEC), Acoustic Echo Canceller (AEC), Noise Suppression(NS), and programmable,
13-tap, Type-I, FIR, Tx/Rx compensation filters. The MSM6280 device's integrated ARM9TDMI
processor downloads the firmware into the QDSP4000 and configures QDSP4000 to support the
desired functionality.
3.7.14 ARM Microprocessor subsystem
The MSM6280 device uses an embedded ARM926EJ-S microprocessor. This microprocessor,
through the system software, controls most of the functionality for the MSM device, including control of
the external peripherals such as the keypad, LCD, RAM, ROM, and EEPROM devices. Through a
generic single serial bus interface (SSBI) the ARM926EJ-S configures and controls the functionality of
the RTR6275, and PM6650 devices.
3.7.15 Mode Select and JTAG Interfaces
The mode pins to the MSM6280 device determine the overall operating mode of the ASIC. The options
under the control of the mode inputs are Native mode, which is the normal subscriber unit operation,
ETM mode, which enables the built-in trace mode, and test mode for factory testing. The MSM6280
device meets the intent of the ANSI/IEEE 1149.1A-1993 feature list. The JTAG interface can be used
to test digital interconnects between devices within the mobile station during manufacture.
LGE Internal Use Only Copyright © 2008 LG Electronics. Inc. All right reserved.
- 52 -
Only for training and service purposes