NPL-4/5/RM-104
Troubleshooting Instructions
The Phoenix window should now look like this:
Now the measurement equipment should detect the following output signal of the
phone:
P
= +24 dBm @ 836.6 MHz
out
If this is not the case, then go to the chapter EDGE for the troubleshooting.
Start the preparations as described in Check synthesizer Operation .
Fault Finding Chart for GSM850 Transmitter
In the following, it is assumed that the TXP signal is used as trigger-signal. For that a
TXP test point is provided.
Copyright © 2005 Nokia Corporation. All rights reserved.
Page 32
Company confidential
Figure 21: RF Controls
Nokia Customer Care
Issue 2 05/05