Daewoo DE12 Shop Manual page 73

3.3.21. Rocker arm assembly
1) Apply lubricating oil to the rocker arm
bush and shaft, and assemble the inter-
mediate bracket with the rocker arm
using fixing bolts.
2) Semi-install valve clearance adjusting
bolts onto the rocker arm.
3) Install the washer, rocker arm, spring,
rocker arm, washer, bracket, spring,
washer, and snap ring in the described
sequence.
4) Install the rocker arm and bracket in the
same direction.
3.3.22. Cylinder head
1) Install the injection nozzle fixing stud
bolts and water pipe fixing stud bolts.
2) Clean the head bolt holes on the cylin-
der block with compressed air to
remove foreign substances and thor-
oughly clean the gasket fitting face of
the cylinder block.
3) Install head gasket, with 'TOP' mark
facing upward, on the cylinder block by
aligning the holes with dowels.
4) Check the inside of combustion cham-
ber for foreign substances, and careful-
ly mount the cylinder head assembly in
the block by aligning the dowel pin with
the dowel pin hole. Be careful not to
damage the head gasket. If the dowel
pin is not in alignment, lift the cylinder
head again and then re-mount it.
5) Coat the head bolts with engine oil,
then tighten them in proper sequence
to the specified torque(24.5kg • m).
EQM3079I
EQM3080I
EQM3081I
- 70 -
TOP