Upgrade Failed - ATEN CL5708 User Manual

CL5708 / CL5716 User Manual

Upgrade Failed

If the firmware upgrade fails (Upgrade Succeeded screen does not appear), you
can recover the situation.
Possible reasons for firmware upgrade failure are:
 When a firmware upgrade was manually aborted.
 When the unit's firmware becomes corrupted for some reason and you are
unable to operate it.
 When a firmware upgrade procedure is interrupted.
 When a firmware upgrade procedure fails.
To recover a failed firmware upgrade, do the following:
1. Click Cancel to close the Firmware Upgrade Utility.
2. Power off the unit.
3. Connect the firmware upgrade cable to its firmware upgrade port.
4. Slide the firmware upgrade switch to the Recover position.
5. Power the unit back on and repeat the upgrade procedure (see Starting the
Upgrade on page 57).
6. After the unit has been successfully upgraded, power it off, and slide the
firmware upgrade switch back to the Normal position.
7. Power the unit back on again.
60