Table of Contents
Advertisement
Available languages
Available languages
English
Joining Extension Assembly to the Handle
Assembly (Fig. T–V)
The two assemblies which make up the extension pole
assembly are keyed to insure a correct assembly. If an assembly
does not smoothly attach to another do not force fit.
To attach the handle assembly to the extension assembly:
1. Align the groove
35
end of the handle assembly
on the inside of the coupling end of the extension
assembly
26
. Refer to Fig. T Push the two sections
completely together. Refer to Fig. U.
2. Slide the threaded sleeve
down as far as possible and rotate the sleeve clockwise
until tightened and completely covers the threads as
shown in Fig. V.
WARNING: Always check to make sure that the sleeve
is completely threaded on and that the threads are no
longer visible. Not threading the sleeve completely on
could result in the assemblies becoming disconnected
creating a hazardous condition. Periodically check the
connections to insure that no threads are visible.
Fig. T
Fig. U
Fig. V
Attaching Extension Cord to Pole Saw
(Fig. A, W)
An extension cord retainer
saw switch handle. It prevents the extension cord from
coming unplugged.
1. Double the extension cord and insert it into the slot
in the end of the handle area as shown in Fig. W.
2. Hook the loop formed by doubling the cord over the
cord retainer
21
. Gently tug on the cord to ensure that
it is firmly retained in the handle.
14
on the outside of the coupling
24
with the tongue
27
on the extension assembly
35
24
26
36
21
is built into the pole
3. Plug the receptacle end of the extension cord into the
power cord
NOTE: Always keep the extension cord away from the
cutting area and position the extension cord so that
it will not be caught on branches, and other material,
during cutting.
Fig. W
36
Joining Chainsaw and Extension Pole
Assembly (Fig. A, X– AA)
WARNING: Sharp moving blade. To prevent
accidental operation, insure that unit is off and
disconnected from a power source before performing
the following operations. Failure to do this could result
in serious personal injury.
WARNING: Always completely assemble the
extension pole assembly together before attaching the
chainsaw to the extension pole assembly.
Adding the extension pole assembly
creates a pole saw that is approximately 10' (3 m) in length.
1. Remove the pole saw adapter plate
saw adapter
counterclockwise. Refer to Fig. X
2. Align the pole saw adapter
chainsaw handle
3. Place the pole saw adapter plate
27
of the chainsaw handle
completely together so the chainsaw handle is clasped
between the two. Refer to Fig. Z.
4. Secure the pole saw adapter plate
adapter
28
locking knob
WARNING: Check to make sure that the adapter plate
is completely threaded on and that the chainsaw
if fully secured. Not fully securing the adapter plate
and adapter to the chainsaw on could result in
the assemblies becoming disconnected creating a
hazardous condition. Periodically check the connections
to insure that the assembly is fully secured.
5. Plug the receptacle end of the pole saw adapter power
cord
33
into the chainsaw power cord
in Fig. AA.
Fig. X
38
28
23
of the pole saw.
18
29
28
by twisting the locking knob
28
on the inside of the
10
. Refer to Fig. Y
29
10
and push the two sections
29
to the chainsaw handle
10
30
clockwise until tight. Refer to Fig. Z.
21
38
to the chainsaw
37
from the pole
30
on the outside
and pole saw
by twisting the
12
as shown
30
29
Hide quick links:
Advertisement
Table of Contents
