Maintenance; Troubleshooting - Ranger RFJ-2TX Installation And Operation Manual

Maintenance

Make sure your Floor Jack is maintained on a regular basis.
• Daily: Keep the Floor Jack clean and dry; if it gets wet or dirty, make sure to clean it.
• Monthly: Oil the pivot points to make sure they continue to work properly.
Adding or Replacing Hydraulic Fluid
The Floor Jack requires Hydraulic Fluid in the Hydraulic System.
When adding or replacing Hydraulic Fluid, always use quality Hydraulic Fluid; do not use brake fluid,
alcohol, detergent motor oil, or dirty oil.
To Add Hydraulic Fluid:
1. Make sure the Saddle and Jack are fully lowered.
2. Remove the Filler Screw.
3. Using approved fluid, add Hydraulic Fluid until it reaches the top of the Filler Screw Hole.
If the level is below the Filler Screw Hole, add Hydraulic Fluid as needed.
4. Replace the Filler Screw.

Troubleshooting

This section describes how to troubleshoot your Floor Jack.
Issue
Floor Jack will not lift load.
Floor Jack cannot sustain load or
feels "spongy" under load.
Floor Jack will not raise fully.
Floor Jack will not lower fully.
Handle raises while the Floor Jack is
under load.
If you continue to have issues with your Floor Jack, visit
call BendPak Ranger at (805) 933-9970.
2-Ton Long-Reach Floor Jack
Action to take
Remove any air trapped in the Hydraulic System.
Remove any air trapped in the Hydraulic System.
Check the oil level; if low, add more.
Check the oil level and make sure there is not too much oil
in the system.
Pump the Handle several times to push oil past the valves
in the pump.
https://www.bendpak.com/support/
8
P/N 5900387 — Rev. B2 — May 2020
or