RML-1100 Scissor Jack
The RML-1100 Scissor Jack lets you get motorcycle wheels up off the ground or the lift, making service easier.
The components of the Scissor Jack are:
• Base. Anchors the Jack.
• Platform. Holds either the Vehicle or the
Saddle Pads.
• Saddle Pads. Use is optional. Cradle the
lifting point(s) of the Vehicle.
• Spindle. Crank clockwise to raise, counter-
clockwise to lower.
• Handle. Turns the Spindle.
Specifications
• Weight Capacity: 1,100 lbs / 499 kg
• Lowered Height: 6.5 in / 150 mm
• Maximum Height: 19.5 in / 495 mm
• Size: 11 by 22 in / 279 by 559 mm
Safety Instructions
• Never exceed the weight capacity. This voids the warranty and increases the chances the Vehicle will fall,
damaging the load and/or the Scissor Jack, and injuring the Operator.
• Only use the Scissor Jack on a flat, dry, hard surface capable of sustaining the weight of the Vehicle.
• Always keep the Vehicle centered and balanced. Make sure the Vehicle is secure before starting work.
• Never work under the Vehicle. Keep all body parts away from all pinch points.
• Always keep Scissor Lift dry and clean. Check unit carefully before each use.
• Do not use the Jack while tired or under the influence of drugs, alcohol, or medication.
• Ranger recommends wearing leather gloves, steel-toed work boots, ANSI-approved eye protection, and
back belts when using the Scissor Jack.
• If Vehicle looks as if it may fall, evacuate the area immediately. Lower Vehicle when safe to do so.
© 2020 BendPak Inc. All rights reserved.
1 of 2
Quick Start Guide
P/N 5900012 — Rev. B — Feb. 2020
1645 Lemonwood Dr.
Santa Paula, CA, 93060 USA
(800) 253-2363
rangerproducts.com