Please Do Not Return This Product To The Store - Bissell 1694-W User Manual

T
roubleshooting
Reduced Spray OR No Spray.
Possible cause
5. The pump belt may be broken.
DirtLifter PowerBrush Does Not Turn.
Possible cause
1. The brush belt or pump belt is off or broken.
Cleaner Not Picking Up Solution
Possible cause
1. Nozzle window may not be properly attached.
2. 2-in-1 tank lid is not installed.
3. 2-in-1 tank is not properly seated.
4 2-in-1 tank has picked up maximum dirty water.
Other maintenance or service not included in the manual should be performed by an
Thank you for selecting a BISSELL product.

Please do not return this product to the store

For any questions or concerns, BISSELL is happy to be of service.
10
w w w . b i s s e l l . c o m
ug120-4007_1694-8806_507.indd 10 ug120-4007_1694-8806_507.indd 10
Lift Here
Insert Screwdriver
Blade Here
authorized service representative.
Contact us directly at 1-800-237-7691.
Remedies
5. Turn power Switch OFF (O) and unplug
from the outlet. To check if a pump
belt has broken, you will need a flat head
screwdriver. Insert the blade end into the
lower slot of the belt access door to release
the lower snap. If necessary, insert the balde
end into the upper slot to release the upper
snap. Examine the belt for breakage. You
should be able to see the pump belt looped
around the motor shaft. If it is broken or
missing, please refer to Replacement Parts
on page 11 before calling BISSELL Consumer
Services. Complete installation instructions
will accompany the replacement belt.
Remedies
1. Turn the machine OFF (O) and unplug from
the outlet. To check if the brush belt or
pump belt has broken, you will need a flat
head screwdriver. Insert the blade end into
the lower slot of the belt access door to
release the lower snap. If necessary, insert
the blade end into the upper slot to release
the upper snap. Examine the belt for
breakage. If broken, please refer to Replacement
Parts on page 11 before calling Consumer
Services. Complete installation instructions
will accompany the replacement belt.
Remedies
1. Make sure the tabs on the floor nozzle
window are inserted through the mating slot
in the main housing. Re-install if necessary.
2. Re-install lid; refer to the Operation section.
3. 2-in-1 tank must be firmly seated to function;
remove and reseat 2-in-1 tank.
4. Empty 2-in-1 tank and refill, refer to the
Operation section.
8 0 0 . 2 3 7 . 7 6 9 1
6/4/07 2:47:48 PM 6/4/07 2:47:48 PM