Table of Contents
Advertisement
has been created. Press any key to reboot the system
6.
Proceed with normal FDISK and format procedures as if you had just installed
a new hard drive.
7.
Once the arrayed drives have been formatted, proceed to the Installing
Driver chapter on page 28 to install your operating system and/or FastTrak
376 driver.
Creating a Security Array With An Existing Data Drive
NOTE
: FastTrak 376 permits only two drives to be used for a single Mirrored
array in Auto Setup.
You would use this method if you wish to use a drive that already contains data
and/or is the bootable system drive in your system. You will need another drive of
identical or larger storage capacity.
WARNING:
Failure to follow this accepted PC practice could result in data
loss.
WARNING:
using the Windows NT 4.x or Windows 2000 operating system as
part of a
376, do NOT connect the hard drive to the FastTrak
376 controller yet. You MUST install the Windows NT4 or 2000
driver software first (see page28) to this drive while it is still
attached to your existing hard drive controller. For all other
Operating Systems, proceed here.
Follow these steps:
Using the Spacebar, choose "Security" under the Optimize Array for section.
1.
2.
Press <Ctrl-Y> keys to Save your selection. The window below will appear.
Array has been created.
<Press Any Key to Reboot>
Backup any necessary data before proceeding.
If you wish to include your current bootable drive
bootable Mirrored (RAID 1) array on your FastTrak
39
Mainboard Features
Advertisement
Table of Contents
