Connection Procedures; Connecting To A Power Supply - ResMed VS Ultra Patient Manual

3 Connection procedures

Place the device on a flat surface. Ensure the area is dust-free, and
cleared of any objects that could block the dust filter.
CAUTION
!
Be careful not to place the device where it could be knocked over or
where someone is likely to trip over the power cord.

3.1 Connecting to a power supply

1. Plug the power cable into the rear of the device
(see Figure below).
2. Remember to push down the fastening clip to hold the power cord
in place. This will prevent accident disconnection of the power
supply
3. Plug the cable into the mains power supply
1
Figure 11: Connection to mains power supply.
Your device is now in standby mode.
.
2
.
3
Connection procedures
11