Nylon Cutting Head - Makita DUR190U Instruction Manual

Installing the cutting tool
NOTE: The type of the cutting tool(s) supplied as the
standard accessory varies depending on the countries.
The cutting tool is not included in some countries.
NOTE: Turn the tool upside down so that you can
replace the cutting tool easily.

Nylon cutting head

NOTICE:
Be sure to use genuine Makita nylon
cutting head.
While holding down the spindle lock button, place the nylon
cutting head onto the spindle and tighten it securely by hand.
4
5
2
3
► 1. Nylon cutting head 2. Spindle 3. Spindle lock
button 4. Loosen 5. Tighten
To remove the nylon cutting head, loosen the nylon
cutting head while holding down the spindle lock button.
NOTE: You can use the supplied hex wrench to
install/remove the cutting tool. Insert the hex wrench
to the hole as shown in the figure to lock the spindle.
► 1. Hex wrench 2. Hole
CAUTION:
Always use the supplied wrenches
to install/remove the cutting tool.
CAUTION:
Be sure to remove the hex wrench
inserted into the tool head after installing the cutting tool.
Adjusting the handle/hanger
position
Adjust the handle and hanger position to obtain com-
fortable handling of the tool.
For DUR190U and DUR191U
Adjust the handle/hanger position so that the tool
comes within the range as shown below.
1
1
1
2
3
Loosen the hex socket head bolts on the bottom of the
handle holder. Move the handle to a comfortable work-
ing position and then tighten the bolts.
1
2
► 1. Handle holder 2. Hex socket head bolt 3. Handle
1
11 ENGLISH
3
The hanger position from the ground
The cutting tool position from the ground
The horizontal distance between the hanger and the
unguarded part of the cutting tool
3
2
2