Table of Contents
Advertisement
865G Micro 775
Onboard Serial Port 2
Select an address and corresponding interrupt for the first and second serial ports
The Choices: 2F8/IRQ3 (default), Disabled, Auto, 3F8/IRQ4, 3E8/IRQ4,
2E8/IRQ3.
UART Mode Select
This item allows you to determine which Infrared (IR) function of onboard I/O
chip.
The Choices: Normal (default), ASKIR, IrDA, SCR .
UR2 Duplex Mode
Select the value required by the IR device connected to the IR port. Full-duplex
mode permits simultaneous two-direction transmission. Half-duplex mode
permits transmission in one direction only at a time.
The Choices: Half (default), Full.
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with
which I/O Address.
The Choices: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
The default value is SPP.
SPP (default)
EPP
ECP
ECP+EPP
ECP Mode Use DMA
Select a DMA Channel for the port.
The Choices: 3 (default), 1.
Power After Power Fail
This setting specifies whether your system will reboot after a power fail or
interrupts occurs.
Off
Leaves the computer in the power off state.
On
Reboots the computer.
Former-Sts
Restores the system to the status before power failure or
interrupt occurs.
The Choices: Off (default), On, Former-Sts.
Using Parallel port as Standard Printer Port.
Using Parallel port as Enhanced Parallel Port.
Using Parallel port as Extended Capabilities Port.
Using Parallel port as ECP & EPP mode.
23
Advertisement
Table of Contents
