Advertisement
2. Install the decals in the area shown in Figure 5. Do not
place the decals over the model/serial number
decal.
2
Figure 5
1. Location of decal number
100–1175
Operation
Using the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Ensure that the discharge door handle is fully forward
and the pin is engaged in the catch (Fig. 6).
1
Figure 6
1. Bag frame on retaining
post
2. Pin contacting latch plate
3. Slide the hole in the bag frame onto the retaining post
on the discharge tunnel (Fig. 6).
4. Set the rear of the bag frame onto the lower handle.
5. Open the discharge door by, pulling the discharge door
handle forward until the pin clears the ramp on the bag
door and moving the handle rearward until the pin
locks in the bag notch (Fig. 7).
1
420
2. Location of decal number
99–6018
2
1912
3
3. Handle fully
forward–discharge door
closed
1
1. Pin in bag notch
DANGER
POTENTIAL HAZARD
A worn grass bag could allow small stones and
other similar debris to be thrown in operator's
or bystanders direction.
WHAT CAN HAPPEN
Thrown objects can cause serious personal
injury or death to the operator or bystanders.
HOW TO AVOID THE HAZARD
Check the grass bag frequently. If it is
damaged, install a new Toro replacement bag.
DANGER
POTENTIAL HAZARD
Thrown objects may result if the discharge
door does not close completely.
WHAT CAN HAPPEN
Thrown objects can cause serious personal
injury or death.
HOW TO AVOID THE HAZARD
If the discharge door cannot be closed because
grass clippings clog discharge area, stop the
engine and gently move the discharge door
handle back and forth until the door can be
closed completely. If the door still cannot be
closed, remove the obstruction with a stick; not
your hand.
6. Cut grass until the bag is full.
IMPORTANT: Do not overfill the bag.
7. Stop the engine and wait for all moving parts to stop.
8. Pull the discharge door handle up and out of the bag
notch (Fig. 7) and pull it forward until it engages the
catch (Fig. 6).
3
Figure 7
1913
Advertisement
