BenQ SE2241 Product Service Manual page 23

(8) Remote Controller
The remote control is a standard accessory packed with the LCDTV set. The communication
between remote control and receiver on LCDTV set is commonly by the emitting and
receiving of infrared signals.
Power/standby
1.
Press this button to power the TV on or put it to
the standby mode.See "Power on,off
standby" .
INPUT
2.
Press this button to select an input source (except
TV input). See "Switching to other input sources
(except the TV input)" .
TV
3.
Press this button to switch to the TV input directly
and view TV programs. See "Selecting the TV
input directly" .
Index
4.
Press this button to go to the Teletext index page.
See "Using the Teletext function" .
Freeze/Teletext freeze
5. /
.Press this button to freeze the image on the
screen. Press the button again to resume viewing
in real time. See "Using the freeze function"
.When Teletext displays on-screen, press this
button to freeze Teletext messages. Press it again to
restore normal update. See "Using the Teletext
function" .
Aspect/Teletext size
6. /
.Press this button to adjust the screen image aspect
ratio. See "Using the Teletext function"
.When Teletext displays on-screen, press this
button to enlarge Teletext size. Press it again to
resume normal size. See "Using the Teletext
function".
Teletext Subpage
7.
Press this button to enter the subpage of a Teletext
menu. See "Using the Teletext function".
Reveal
8.
Press this button to display any concealed Teletext
information (such as answer to a quiz). See "Using
the Teletext function" .
Mode
9.
Press this button to cycle the Teletext display mode
between Teletext
superimposed on the display. See "Using the
Teletext function" .
23
only or with Teletext
and