Cavity Light; Replacing The Lamp; Convection Fan And Motor; Replacing The Convection Fan Blade - Bosch 800 Series Service Manual

58300000194725 ARA EN B
3. Position the new display board so that the slots in the board
align with the four metal tabs, and firmly push the board
downward until it is securely in place.
4. Slightly re-twist each of the four metal tabs.
5. Reassemble the control panel.
6. Reattach the control panel to the range.
7. Restore power and test operation.
6.4

Cavity Light

Each oven cavity uses one incandescent 40W appliance bulb with a
standard Edison base (E26). Replacement bulbs may be purchased
locally.
The cavity light can be turned on in two ways: by pressing Oven Light
or opening the oven door. If Oven Light had not been pressed to turn
light on prior to opening the oven door, the light will turn off when the
door is closed. If Oven Light had been pressed to turn light on prior to
opening the oven door, the light will remain on after the door is closed.
In other words, the Oven Light switch overrides the door.
6.4.1

Replacing the Lamp

CAUTION
 Turn off power to the range at the fuse or breaker box: light
socket is live with door open.
 Be sure oven and lights are cool to the touch.
 Handle glass lenses and glass bulbs carefully.

NOTICE
Sometimes, after running a self-clean cycle at high heat, it may become
difficult to remove the glass lens. If it cannot be done by hand, an
adjustable strap-wrench may be used.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2016
1. Unscrew glass lens cover by turning it counter-clockwise.
Figure 24 Removing the glass lens
2. Unscrew the appliance bulb by turning it counter-clockwise.
3. Insert the new bulb.
4. Replace the glass cover.
5. Restore power to the unit and test the operation of the light.
6.5
All 800 series gas slide-in ranges have a convection fan on the rear
cavity wall.
Depending on the cooking mode selected, the fan may be used to
circulate heat evenly throughout the cavity.
The fan blade is easily accessed on the rear wall of the oven cavity
behind the convection baffle. Replacing the convection fan motor will
require access to the rear of the unit.

6.5.1 Replacing the Convection Fan Blade

1. Remove power to the range.
2. Remove the screws securing the convection baffle to the rear
wall of the oven cavity.
3. While holding the fan blade, loosen the nut by turning it
clockwise; set the nut and washer aside.
4. Remove the fan blade from the shaft of the motor, noting that
there is a second washer behind the fan blade.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch 800 Series Gas Slide-in Ranges

Convection Fan and Motor

Page 20 of 36
800 944-2904