Multifunction Display; Adjusting The Buzzer Volume (Buzz) - Fiat DOBLO 2016 Owner's Handbook Manual

Table of Contents

Advertisement

Adjusting the buzzer
volume (bUZZ)
This function is used to adjust the
volume of the audible signal (buzzer)
that sounds in the event of failure/
warning indications and when
the MENU ESC,
and
buttons are
pressed.
To set the desired volume, proceed as
follows:
- press the MENU
button briefly:
the display will show the wording
(bUZZ);
- press
or
to select the required
volume (adjustable over 8 levels).
- press the MENU
button briefly to
return to the menu screen or hold the
button down to return to the standard
screen without storing.
Activation/Deactivation
of passenger side front
and chest/head side
protection (side bags)
airbags (BAG P)
(for versions/markets, where
provided)
This function allows the passenger side
airbag to be activated/deactivated.
Proceed as follows:
- press the MENU
button and, after
the message BAG P OFF (to
deactivate) or BAG P On (to activate) is
displayed by pressing buttons
, press MENU
again;
- a confirmation message will appear
on the display;
- press the
or
(YES) (confirming activation/
deactivation) or (no) (to abort);
- press the MENU
message confirming the selection will
be displayed and you will return to
the menu screen or, pressing the button
for longer, you will return to the
standard screen without saving.
Daytime running lights
(DRL)
This function allows you to activate/
deactivate the daytime running lights.
Proceed as follows to activate or
deactivate this function:
- press the MENU
the display will show the wording DRL;
- press the
or
(On) or deactivate (Off) the daytime
running lights;
- press the MENU
return to the submenu screen or hold
the button down to return to the main
menu screen without saving;
or
MULTIFUNCTION
DISPLAY
buttons to select
(for versions/markets, where provided)
The vehicle may be equipped with a
multifunction display that gives the
button briefly: a
driver useful information depending on
the previous settings.
STANDARD SCREEN
The standard screen fig. 116 can
display the following information:
A Date
B Milometer (distance covered in km or
miles).
C Time (always displayed, even with the
key extracted and the front doors
closed).
button briefly:
D Outside temperature.
E Headlamp alignment position (only
button to activate
with dipped headlamps on).
F Start&Stop function indication (for
versions/markets, where provided).
button briefly to
G Gear Shift Indication (for versions/
markets, where provided).
Note When one of the front doors is
opened, the display is activated,
showing the time and mileage for a few
seconds.
73

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents