Advertisement
SC-F3030 Print Head replacement
Things to take note before performing Print Head replacements: -
Only
Print Head
•
Replace Print Head only if
•
Use User Self Repair Diagnosis to determine Print Head replacement
•
Nozzle compensation
•
Adjustment Film Sheet
•
M size platen
•
Make sure printer connected to "Internet".
•
WORKFLOW for
REPLACING PRINT HEAD
When a Print Head Needs to Be Replaced?
A Print Head needs to be replaced in the following situations.
**If a number other than those above is displayed, contact your dealer or
Epson Support and tell them the 16-digit code.
When print results are not correct:
If the print results are not improved after doing the following measures, start the printer in User Self Repair Mode and
do a Diagnosis.
❏ Execute Head Cleaning - Cleaning (Heavy)
If the clogs are not cleared after doing this once, then execute Cleaning (Heavy) again one more time.
❏ Clean around the Print Heads and the edges of the metal
❏ Clean the Suction Cap
❏ Replace the Anti-Drying Caps
For the procedures to clean and replace the various parts, refer to User's Guide -
Only replace a Print Head with a replacement one if the
-----------------------------------------------------------------------------------------------------------------------------------------
can be replaced in this mode
Print Head reached end of life
"Turn
On".
- For Print Head Nozzle Check and Adjustments
-
Remove
grip pad.
or
Print results are not
(The work is different for both/two situations.
A Print Head has reached the end of its
service life if any of the following 16-digit
numbers appears in the enclosure shown
on screen.
0000020000000000/0000040000000000
/0000060000000000
Take note of the number, then press
Replace Parts to turn off the printer. Next,
start the printer in User Self Repair
Mode, and then replace the Print Head
with the replacement one.
Maintenance.
determines that a Print Head needs to be replaced.
Diagnosis
right!
)
Advertisement
