Setting The Temperature; Super Function; Setup Mode - Siemens S18ID Series Operating And Care Instructions

Setting the
temperature
The temperature can be set from
+7 °F to –9 °F (–14 °C to –23 °C).
We recommend a setting of
0 °F (–18 °C).
The temperature can be changed
with the + buttons (warmer) or –
(colder). The temperature can be
adjusted in 1 °F (0.5 °C) steps.
To adjust the required temperature:
Activate the Setup mode with
the or buttons.
< >
The FREEZER symbol is
displayed.
Set the required temperature
with the + (warmer) or – (colder)
buttons.
Depending on the model, the
appliance can also be switched
off or switched to Vacation
mode via the temperature
setting. When the highest
temperature has been reached,
is displayed.
OFF
10

Super function

The Super function is used to freeze
large quantities of fresh food and
should be switched on some hours
before the fresh food is placed in the
freezer. In general, 4–6 hours is
adequate. If the maximum freezing
capacity is used, 24 hours are
required.
When the Super function is
activated, the appliance is cooled as
cold as possible to a preset
temperature set at the factory.
The function is activated by pressing
the super button.
$
The symbol and the Super
SUPER
temperature are displayed.
The function is ended:
– by pressing the super button
again,
– by activating the Eco function,
– by activating the Vacation mode,
– by activating the Sabbath mode.
After approx. 2 ½ days the
freezer automatically switches
back to the temperature set
before Super function.

Setup mode

There are several menus for
adjusting the appliance functions to
individual requirements.
These adjustments can be made in
Setup mode.
To activate Setup mode:
Press the setup button.
The first menu (temperature unit) is
displayed.
To switch to the next menu:
Press the or button.
< >
The next menu and the current
setting (usually On/Off) are displayed.
To select between the different
setting options within one menu:
Press the + or – button.
A modified setting is saved
when the next menu is selected
with the or button.
< >
To end Setup mode:
Press the setup button.
All modified settings are saved.
If no button is pressed within
12 seconds, Setup mode ends
automatically. All modified
settings are saved. The required
temperature is displayed again.