Controls And Features; Power Up Test Sequence; Operating Mode - Beltronics Vector 945 Owner's Manual

POWER-UP TEST SEQUENCE/
START-UP MODE
Press the PWR button to turn the unit ON.
Depending upon the Operating Mode
selected, the power up test sequence and
confirmation of Radar/Laser/SWS
will be relayed to you as follows:
NORMAL (Factory Pre-Set Mode)
A lengthy, power up test sequence that
displays audio and text messages for
laser, Ka, K, X and Safety Warning
System (SWS ) followed by the status
® ™
of the General Selectable Features each
time the unit is turned on. When
complete, unit is ready for operation
and will display Radar, Laser and SWS
messages when signals are detected.
Normal Mode is recommended when
first using your
V945
MODS (Modifications Mode)
Presents audio and text messages for
Laser, Ka, K, X and Safety Warning
System (SWS ), followed by ONLY
® ™
those Selectable Features which have
been modified by the user from their

Controls and Features

Q-START (Quick-Start Mode)
alerts
™
™
.
8
Factory pre-set state each time unit is
turned on. Unit is ready for operation
and will display Radar, Laser and SWS
messages when signals are detected.
Unit will bypass the power up test
sequence and will display the last
selected traveling mode:"Au t o Sc a n
(factory default) "Hi g h w a y ", "C i t y
X " or "Cit y ALL". Q-Start is
recommended when you are
comfortable with the detector and do
not require a rundown of sample
messages. Unit is ready for operation
and will display Radar, Laser and SWS
messages when signals are detected.
Whichever Operating mode you select,
will be in standby mode and
V945
ready to detect traffic Radar, Laser and
SWS™ signals. The display will show
"Au t o Sc a n " (factory pre-set which is
suitable for ALL driving conditions, unless
you change this to "Hig h w a y ", "C i t y X " or
"Cit y ALL" (see page 12).
™
"
™
™