Windshield /Visor Mounting; Installation - Beltronics Vector 945 Owner's Manual

WINDSHIELD MOUNTING
1
Remove the mounting bracket cover
on top of the unit by pressing on the
raised dots and pushing outward. Store
the cover in a safe place.
2
Clean the selected windshield area,
position the suction-cup mount on the
windshield, and press firmly on each
suction cup to secure it in place.
3
Use a screw driver or a small coin to
adjust the angle of the suction-cup mount
until the base plate is level.
4
Slide detector onto base plate unit, it
snaps into place.
Note: Some vehicles (including some
Porsches) have a plastic coating on the
inside of the windshield designed to
protect occupants in case of an accident.
Use of the windshield bracket on this type
of windshield can permanently mark the
surface. Check with your dealer if you
are unsure whether your vehicle is
equipped with this type of windshield.

Installation

VISOR MOUNTING
1
Remove the mounting bracket cover
by pressing on the raised dots and
pushing outward. Store the cover in a
safe place.
2
Slide the visor clip onto the top of
the detector until is snaps into place.
Clip the detector to the edge of the sun
visor nearest the windshield.
7