Advertisement
Using your Sunbeam CitrusPress
Before using your CitrusPress
Clean the juicing cones, stainless steel
sieve and juice container in warm
soapy water. Rinse and dry thoroughly.
Alternatively you can place these parts in
the upper section of your dishwasher.
Using your CitrusPress
1. Position the stainless steel sieve onto
the juicing container and place onto the
motor base.
2. Place the small juicing cone onto the
drive shaft. If you are juicing larger citrus
fruits, position the larger juicing cone
over the smaller juicing cone so the large
cone is sitting on top of the smaller cone.
3. Plug the power cord of the CitrusPress
into a 230-240V AC power outlet and
switch the power on.
4. Place a glass under the anti-drip spout.
5. To open the anti-drip spout, push it
downwards to allow the juice to slow into
the glass.
4
6. Cut the citrus segments in half, cutting
across the segments.
NOTE: Before juicing we recommend
that you roll the fruit on the bench whilst
pressing down gently. This way you will
obtain more juice.
7. Press a fruit half onto the juicing cone
–the CitrusPress starts automatically and
stops when the fruit is removed.
8. Push the anti-drip spout upwards to stop
the flow of juice, you can then remove or
exchange the full glass with another –
this ensures that the anti-drip spout does
not allow the juice to continue to flow.
9. When the CitrusPress is no longer
needed, remove the power cord from the
power outlet and clean the CitrusPress –
see "Care and Cleaning" on page 5.
Care and Cleaning
NOTE: Before cleaning always remove the
power cord from the power outlet.
Remove the juicing cones, stainless steel
sieve and juicing container from the motor
part of the base of the CitrusPress.
Clean all parts with warm soapy water.
Rinse and dry thoroughly.
NOTE: For thorough cleaning of the
anti-drip spout, it can be removed from
the juicing container. This ensures that
any residue remaining from the juice is
removed.
Alternatively you can place these parts in the
upper section of your dishwasher.
Clean the motor base of the CitrusPress with
a damp cloth. Never use harsh cleaning or
scouring agents. Never immerse in water or
other liquids.
5
Advertisement
