Sunbeam JEM1000SS - Citrus Press Manual

Sunbeam's Safety Precautions

SAFETY PRECAUTIONS FOR YOUR CITRUSPRESS.

• Handle the moving parts of the device with extreme care and caution.
• Switch power outlet off and unplug before cleaning.

Sunbeam is very safety conscious when designing and manufacturing consumer products, but it is essential that the product user also exercise care when using an electrical appliance. Listed below are precautions which are essential for the safe use of an electrical appliance:

• Read carefully and save all the instructions provided with an appliance.
• Always turn the power off at the power outlet before you insert or remove a plug. Remove by grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug when the appliance is not in use and before cleaning.
• Do not use your appliance with an extension cord unless this cord has been checked and tested by a qualified technician or service person.
• Always use your appliance from a power outlet of the voltage (A.C. only) marked on the appliance.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• The temperature of accessible surfaces may be high when the appliance is operating.
• Never leave an appliance unattended while in use.
• Do not use an appliance for any purpose other than its intended use.
• Do not place an appliance on or near a hot gas flame, electric element or on a heated oven.
• Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang over the edge of a table or bench top or touch any hot surface.
• Do not operate any electrical appliance with a damaged cord or after the appliance has been damaged in any manner. If damage is suspected, return the appliance to the nearest Sunbeam Appointed Service Centre for examination, repair or adjustment.
• For additional protection, Sunbeam recommend the use of a residual current device (RCD) with a tripping current not exceeding 30mA in the electrical circuit supplying power to your appliances.
• Do not immerse the appliance in water or any other liquid unless recommended.
• Appliances are not intended to be operated by means of an external timer or separate remote control system.
• This appliance is intended to be used in household and similar applications such as: staff kitchen areas in shops, offices and other working environments; farm houses; by clients in hotels, motels and other residential type environments; bed and breakfast type environments.

If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or www.sunbeam.co.nz contact the Sunbeam Customer Service Line. Ensure the above safety precautions are understood.

Features of your Sunbeam CitrusPress

Using your Sunbeam CitrusPress

Before using your CitrusPress
Clean the juicing cones, stainless steel sieve and juice container in warm soapy water. Rinse and dry thoroughly. Alternatively you can place these parts in the upper section of your dishwasher.

Using your CitrusPress

1. Position the stainless steel sieve onto the juicing container and place onto the motor base.
2. Place the small juicing cone onto the drive shaft. If you are juicing larger citrus fruits, position the larger juicing cone over the smaller juicing cone so the large cone is sitting on top of the smaller cone.
3. Plug the power cord of the CitrusPress into a 230-240V AC power outlet and switch the power on.
4. Place a glass under the anti-drip spout.
5. To open the anti-drip spout, push it downwards to allow the juice to slow into the glass.
6. Cut the citrus segments in half, cutting across the segments.
   NOTE: Before juicing we recommend that you roll the fruit on the bench whilst pressing down gently. This way you will obtain more juice.
7. Press a fruit half onto the juicing cone – the CitrusPress starts automatically and stops when the fruit is removed.
8. Push the anti-drip spout upwards to stop the flow of juice, you can then remove or exchange the full glass with another – this ensures that the anti-drip spout does not allow the juice to continue to flow.
9. When the CitrusPress is no longer needed, remove the power cord from the power outlet and clean the CitrusPress – see "Care and Cleaning".

Care and Cleaning

NOTE: Before cleaning always remove the power cord from the power outlet.
Remove the juicing cones, stainless steel sieve and juicing container from the motor part of the base of the CitrusPress. Clean all parts with warm soapy water. Rinse and dry thoroughly.

NOTE: For thorough cleaning of the anti-drip spout, it can be removed from the juicing container. This ensures that any residue remaining from the juice is removed.

Alternatively you can place these parts in the upper section of your dishwasher.
Clean the motor base of the CitrusPress with a damp cloth. Never use harsh cleaning or scouring agents. Never immerse in water or other liquids.