Keurig K-2500 Use & Care Manual page 19

K-2500™ BREWER
3
Adding
Descaling
Solution
For Plumbed Brewers:
Open descale solution door and fill
internal tank with approximately half
of the Keurig® Descaling Solution
(approximately 7 oz).
NOTE: The internal tank cannot hold
more than 7 oz.
Close the descale solution door.
For Water Reservoirs:
Replace the reservoir onto the
dock. Next, pour the entire bottle
of Keurig® Descaling Solution
into the empty reservoir. Fill the
empty descaling bottle with
water and add to the reservoir.
DESCALING, CONT.
4
30
Running
Descale
Flip the power switch to ON, and
place a container under the exit
spout. The brewer will begin filling the
hot water tank. Raise the lid handle
to initiate a 12-oz cleansing brew.
Once the brew starts and a full
stream is visible exiting the brewer
(approximately 2 oz), flip the power
switch to OFF to prevent the first
cleansing brew from finishing.
This allows the solution to soak the
entire brew path. Let the brew path
soak for 30 minutes.
NOTE for Plumbed Brewers: While
the brew path is soaking, open the
descale solution door and add the
remaining descaling solution.
After soaking, flip the power switch
back to ON. Raise the lid handle
and complete two additional 12-oz
descaling brews.
5
min
Rinsing the Brew Path
Perform at least 12 cleansing brews
to completely clear the descale
solution and residual from the brew
path. The first four will contain the
majority of the descaling solution.
The last eight should clear any
remaining solution from the walls of
the brew path.
6
x 12
Drying the Puncture
Mechanism (PM)
The PM consists of the entrance
needle (located underneath the lid)
and the exit needle (located inside
of the pod holder assembly). Allow
the PM to dry after completing all
cleansing brews. This can be done
by leaving the lid open for the PM
to air dry.
For descaling steps video:
commercial.keurig.com/training.
19