Table of Contents
Advertisement
OmniGuard
5.0 Useful Tips
1.
If you receive the Device Not Found message even though the device is
actually connected to COM port,
Please check,
Settings screen COM Port is correct
Check COM port is working and not used by another application
Check our DOS prompt, process for agent process as below
The above screen must detect the UPS on the stated COM Port in order to receive the
message, UPS Found.
From here you can also confirm the detection of the UPS.
If all Settings and physical connections are ok, try restarting the PC/server
and check it again.
2.
Any time changes are made in the COM Port, while running the application,
please be sure to stop all applications and re-launch application again to make
the changes effective.
TM
UPS Power Management Software
43
Advertisement
Table of Contents
