6.7.
Clearance adjustment
1. Insert the clearance gauge between the upper cutter surface of spinner (extractor) and the bottom of feeder opening.
2. when the thinner side (1/51''... 0.5mm) can be inserted and the thicker side (1/28''... 0.9mm) cannot, the clearance is appropri-
ate.
3. If the thicker side (1/28''... 0.9mm) can be inserted, the clearance is too large.
In that case, remove the coupler and add some adjustment washers onto the motor shaft.
4. In the thinner side (1/51''... 0.5mm) cannot be inserted, the clearance is too narrow.
In that case, remove the coupler and take off some adjustment washers from the motor shaft.
13