ADTRAN Total Access 300 Series Installation And Maintenance Manual page 52

Total Access 300 Series Single Family Unit ONT Installation and Maintenance Guide
!
CAUTION
■ Electrostatic Discharge (ESD) can damage electronic modules. When
handling modules, wear an antistatic discharge wrist strap to prevent
damage to electronic components. Place modules in antistatic packing
material when transporting or storing. When working on modules, always
place them on an approved antistatic mat that is electrically grounded.
■ This product is intended to operate in ambient temperatures up to 65°C in
restricted access locations Only. This product is also intended to operate in
ambient temperatures up to 46°C in all other locations.
■ Per GR-1089-CORE, this system is designed and intended for installation as
part of a Common Bonding Network (CBN). This system is not designed
nor intended for installation as part of an Isolated Bonding Network (IBN).
■ This equipment contains no parts that can be serviced by the user.
NOTE
■ The Total Access 300 Series is designed to be deployed in GR-3108-CORE
environmental class 3 as defined in GR-3108-CORE. The NID housing with
the ONT installed is located in a class 4 environment.
■ Power supply input and output conductors of equipment, and signal
conductors of equipment which are exposed outside of the building, are
intended to be less that 140 feet (42.6 meters) and have adequate clearance
from power and lightning conductors in accordance with NEC 725 and 800.
Final acceptance of the Listed equipment installation will ultimately be up
to the local Authority Having Jurisdiction (AHJ).
■ This product is designed to operate with a nominal operating voltage of 12
VDC.
The product is designed to meet the applicable requirements of Telcordia GR-63-CORE, and
GR-1089-CORE.
This product is intended for deployment in a NID housing in the Outside Plant Locations (for
example, Customer Premises). This product is to be installed and serviced by trained and
qualified service personnel only. Install this product in a restricted access location by trained
service personnel only in locations where the NEC applies (for example, Customer Premises).
This device is an FCC Class B device. This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
Changes or modifications not expressly approved by ADTRAN could void the user's
authority to operate this equipment.
The equipment meets the EU's RoHS Directive 2002/95/EC and/or applicable exemptions.
Refer to
3-4
HANDLING PRECAUTIONS REQUIRED.
undesired operation.
www.adtran.com for further information on RoHS/WEEE.
C A U T I O N ! C A U T I O N
SUBJECT TO ELECTROSTATIC DAMAGE
OR DECREASE IN RELIABILITY.
612877GONT-5C