Advertisement
Advertisement
Summary of Contents for TELUS PureFibre Internet
- Page 1 TELUS PureFibre Internet Installation Guide © 2020 TELUS. 07/20 2400155...
-
Page 2: Table Of Contents
Before you get started Important: These instructions will guide you to setup your new TELUS PureFibre Internet. If you are replacing existing equipment as part of a repair, locate your existing modem and take a picture of the back of the device, noting which cables are connected to LAN and COAX ports, so you can reconnect those later. -
Page 3: Step 1: Locate And Identify The Fibre Terminal
Step 1: Locate and identify the Fibre Terminal Locate the Fibre Terminal in your home. The Fibre Terminal is generally located in one of the following places: Where fibre comes into the home, often in a communications panel, basement, or garage ■... -
Page 4: Step 2: Connect The Fibre Terminal To The Wi-Fi Hub
POWER and WAN lights are green. Back of TELUS Wi-Fi Hub Use the Ethernet cable included in your kit to connect the yellow LAN/WAN (4) Port on the TELUS Wi-Fi Hub to Data 1 or LAN 1 on the Fibre Terminal. Nokia Fibre Terminal Alcatel... - Page 5 Reconnecting Cables If you were replacing an existing modem, now reconnect any cables that were connected to the LAN or COAX ports on the old device to the same ports on the new TELUS Wi-Fi Hub.
-
Page 6: Step 3: Connect And Setup Your Wi-Fi Network
Step 3: Connect and setup your Wi-Fi network If you have the TELUS My Wi-Fi App, or can download it with mobile data, open the app, follow the onscreen instructions to setup the TELUS Wi-Fi Hub, and skip the rest of Step 3. -
Page 7: Step 4: Connect Other Devices
Optik TV Digital Box, wait 5 seconds, plug power back in, then follow the on-screen instructions to reconnect. Return any old hardware or TELUS equipment you do not need by taking it to a Canada Post ■... -
Page 8: Appendix: Status Light Guide
Appendix: Status light guide Internet Light Behaviour Colour Status No Fibre Connection / error (LED can’t be set to be off) Solid Factory reset Flash Have WAN connection and have Internet connection Solid Device is booting up Flash Firmware updating Flash No Power or LED brightness is set to be off Wi-Fi Light...