Monitor Cycle On Monitor X - Siemens SIMATRIX Programming Manual

Automatic picture cycle
8.1

Monitor cycle on monitor x

62
Siemens Building Technologies
Fire Safety & Security Products
Locking cameras for manual selection
Ticking this option box (only applies to the monitor sequence) also inhibits manual
dial-up to the cameras that have been disabled for the monitor cycle.
I.e. it is only possible to manually switch the cameras that have been enabled for
the monitor cycle. This only applies if the monitor has been enabled for this cycle.
This disabling procedure only applies to individual manual switching. It is not
possible to disable cameras for manual group switching or alarm switching.
In a monitor cycle, the cameras are switched in ascending input number order, e.g.
1-3-4-8-12 etc. (in this case the sequence consists of cameras 1 to 16 on
monitor 1).
Fig. 47 Monitor cycle on monitor x
Tick the boxes here for all the cameras you wish to include in the monitor cycle.
Remember that the cameras are always switched in ascending input number order.
Further monitor cycle parameter settings can be entered in the Setting video
mode switching parameters for monitor x dialogue screen (see section 5.1.2).
If you want to program a preset sequence, click the Cancel button to return to the
dialogue screen where you can select the index cards Position 1..32
(see section 8.2).
All active
The All active button selects all the cameras. This enables all cameras for the
monitor cycle.
This also applies to the cameras that have been programmed on the other index
cards.
06.2008