Remote Control - Power Acoustik PL-52B User Manual

REMOTE CONTROL

Remove Insulating Sheet
The remote control comes with an insulating sheet
attached to the underside of the remote control, as
illustrated on the right. The remote control will not
work until the insulating sheet is removed.
Replace Lithium Battery Cell
1. When the lithium cell battery becomes weak,
replace it as illustrated on the right.
2. Press and hold the movable block in the direction
indicated by arrow 1. At the same time, pull the cell
holder out of the remote control in the direction
indicated by arrow 2.
3. Replace the old cell with a new one, making sure the
(+) polarity is facing upward.
4. Re-insert the cell holder into the remote control.
- Cell leakage may cause damage to the remote control.
- Do not throw cells into as this may cause an explosion.
- Keep battery cells out of reach of children.
Remote Control Operation
Position the emitting window of the remote control toward the sensor window of the unit.
• The operation angle for front panel remote control reception is about 30 degrees.
• The distance between the emitting window of the remote control and the sensor window
of the unit should remain less 5 meters.
Button Names and Locations
1. (Power on/off) button
2. VOL+/VOL-(volume increase/decrease) button
3. Band button,
4. Tune down, seek down; Track down, fast reverse
5. SEL(selection) button
6. button:tune up, seek up; Track up, fast forward
7. Mute button, DEL(Delete) button
8. CLK(clock setting) button,
9. button, preset station 1 button, keypad 1
10. INT(intro) button, preset station
11. RPT(repeat) button, preset station
12. RDM (random)
13. -10(previous 10 tracks)
14. +10(next 10 tracks)
15. ST (stereo) button, keypad 7
16. LOUD(loudness) button, keypad 8
17. AMS (automatic music search) button, keypad 9
18. MODE button, keypad
19. EQ(Equalizer) button, keypad 0
20 . LOC (local)/DX button, keypad #
Note: When using the remote control for the first time, you
must pull out the portective plastic tab from the battery compartment
found on the back of the remote control.
(anser call) button
(end call) button
2 button,keypad 2
, preset station 4 button, keypad 4
, preset station
, preset station
3 button, keypad 3
5 button, keypad 5
6 button, keypad 6
1
4
1
4
7
9
10
12
13
15
18
19
2
3
3
5
2
6
8
11
14
16
17
20
LOC
11