Frost Protection; Drainage Instructions - Haier QPCA08 Installation And User Manual

CONTROLS
The display will always default to show SET temperature.
When the air conditioner is turned on, it will automatically start in the last mode and fan settings selected.
FROST PROTECTION FUNCTION:
In cooling or dry mode, if the temperature of the exhaust
hose is too low, the AC will automatically go into a unit
protection state.
OVERFLOW PROTECTION FUNCTION:
When water in the water pan exceeds the warning level,
the machine will automatically sound an alarm, the FULL
indicator light will flash and the unit will shut down. At this
point, you need to drain the water from the lower drain (See
Drainage instructions for details)
AUTOMATIC DEFROSTING (on some models)
The machine has an automatic defrosting function.
PROTECTION FUNCTION OF THE COMPRESSOR
To increase the service life of the compressor, the AC has a
3-minute delay after the compressor has shut off to protect
the compressor.

DRAINAGE INSTRUCTIONS

Draining the unit manually:
Note: Please move the AC carefully, do not spill the water in
the water pan at the bottom of the unit.
1. When the AC stops after the water is full, turn off the AC
power and unplug the power plug.
2. Place a water container larger than the sump capacity (at
least 1-1/2 quart) below the lower rear water outlet on
the back side of unit.
3. Remove the plug, the water will automatically flow into
the container.
Note: During drainage, the body can be tilted slightly
backwards. If the water container cannot hold all the water,
before the water container is full, replace the water plug as
soon as possible to prevent water from flowing to the floor or
the carpet.
4. After water has been drained from the unit, re-install the
water plug securely.
Note: Restart the AC after the water plug is installed,
otherwise condensate water from the AC will drain onto the
floor or carpet.
Continuous drainage (optional, and only in dry mode)
1. Remove the upper drain plug.
2. Connect a drain hose with an inside diameter of 5/8" to
the water outlet.
3. Route drain hose to a bucket or floor drain.
6
When the temperature rises to a normal temperature, the
unit will automatically resume normal operation.
After the water is emptied, the machine the machine will
automatically resume normal operation.
4. Be sure to use a large container (3 gallons or larger is
recommended) and monitor the water level in the container
continuously. The unit will not shut off when the container
is full. An overflowing container can cause flooding and
damage to the floor.
49-5000543 Rev. 1