Base Installation
Lap Belt Installation
•
Figure A illustrates a typical rear facing lap
belt installation with the restraint attached.
•
If attached, remove restraint before
installing base.
•
When not in use, always store the LATCH
connectors on storage ring at front of base.
1
Place the base in a rear facing position on
the vehicle seat.
2
Open lock-off by lifting both tabs, then
opening lock-off plate (Fig. B).
3
Pull to fully extend vehicle belt.
4
Route vehicle belt under both belt guides
(Fig. C).
5
Verify that the vehicle belt is not twisted,
then buckle.
6
Adjust recline by turning knob on front
of base until correct angle is achieved.
•
When correctly reclined, the red line on
base will be level with the ground.
•
If there is a problem stabilizing the base,
place a rolled towel in the crease of the
vehicle seat to help level the base.
WARNING:
Only raise base as described
above. Do not raise the base off of the
front edge of vehicle seat; doing so will
reduce the protection for your child.
24
A
B
C
7
Push the base firmly into the seat while
removing slack from the vehicle belt (Fig.
D).
8
Close lock-off plate over the vehicle belt,
then secure by closing both tabs while
pressing firmly on the lock-off plate.
•
Lock-off is properly secured when tabs are
flat against lock-off plate.
9
Verify that vehicle belt is tight and that
the base is stable.
B B a a s s e e R R e e m m o o v v a a l l : :
Remove restraint, then open lock-off and
remove vehicle belt from belt guides.
Base Installation
D
E
25