Base Installation
LATCH Installation
•
Figure A illustrates a typical rear facing
LATCH installation.
•
Verify that your vehicle is equipped with
LATCH anchors. If LATCH anchors are not
installed, you must use vehicle belt
installation methods.
1
Disconnect LATCH connectors from
storage ring on the front of the base.
2
Open lock-off by lifting both tabs, then
opening lock-off plate (Fig. B).
3
Press and hold the LATCH adjuster
release button, then pull to lengthen
LATCH harness to full length.
4
Place the base sideways on the vehicle
seat, with the anti-rebound bar facing you.
5
Verify that the LATCH harness is not
twisted, then attach the farthest
connector to farthest LATCH anchor in
desired seating position (Fig. C).
•
A positive click confirms attachment.
6
Rotate base into rear facing position with
anti-rebound bar against vehicle seat back.
7
Verify that the LATCH harness is not
twisted, then attach the closest
connector to closest LATCH anchor in
desired seating position (Fig. D).
•
A positive click confirms attachment.
20
A
B
C
8
Adjust recline by turning knob on front
of base until correct angle is achieved.
•
When correctly reclined, the red line on
base will be level with the ground.
•
If there is a problem stabilizing the base,
place a rolled towel in the crease of the
vehicle seat to help level the base.
WARNING:
Only raise base as described
above. Do not raise the base off of the
front edge of vehicle seat; doing so will
reduce the protection for your child.
9
Push the base firmly into the vehicle seat
while pulling each LATCH harness tight
(Fig. E).
10
Close lock-off plate over the LATCH
harness, then secure by closing both tabs
while pressing firmly on the lock-off
plate (Fig. F).
•
Lock-off is properly secured when tabs are
flat against lock-off plate.
11
Verify that all connections are secure and
the base is stable.
B B a a s s e e R R e e m m o o v v a a l l : :
Release each LATCH harness from the
LATCH anchor by pressing the release
button on the LATCH connector.
•
When not in use, always store the LATCH
connectors on storage ring at front of base.
Base Installation
D
E
F
21