Dorsal Hydromassage (R + L); Dorsal Hydromassage - Jacuzzi flexa DOUBLE Use & Maintenance

Dorsal hydromassage

G Flexa Tower - Thema
• Adjust the water temperature and set up the function as indi-
cated in the chapter on the "Shower" function.
I Mod. ST2
Is equipped with 4 simultaneous water jets, which perform
their action on the dorsal zone of the seated user.
• (fig. 1) Turn the knob of the deviator to the indicated position.
I Mod. ELT3
These models also include 4 simultaneous water jets, but they
are electronically controlled via the display.
• After turning the knob to the indicated symbol (fig. 2), press
the key on the display as shown in fig. 3. The corresponding LED
comes on and water is dispensed from the dorsal jets.
• If you again press the key in fig. 4 the function stops.
I Mod. ELT 4-8-20BT-22
(Flexa Tower, Thema)
In these models, there are 8 water jets that work in sequence,
one at a time, from bottom to top.
The speed of movement is pre-set at the factory, but it can
be varied according to user preferences.
• Set up the function as indicated for the previous models (fig.2)
and press the corresponding key (fig.4).
• If you wish, you can change the sequence speed as follows:
when you press the key in fig. 5, the corresponding scale of
LED's starts flashing. By pressing the "+" and/or "-" keys, you
can change the set speed, shown on the display (fig.6). If how-
ever these keys are not pressed within 6 seconds, you will have
to press the key again to make the change.
• If you press the key again the function stops.
G Flexa Double
These models are equipped with 16 jets, 8 on the left wall and
8 on the right. Both of them act on the dorsal area, but the
methods of managing and operating them are different. The jets
on the left are managed manually (and operate at the same
time) whereas those on the right are managed via a display and
operate sequentially (two at a time, from the bottom to the top).
I The two sets of jets can be used independently by pro-
ceeding as follows:
• Adjust the water temperature and set up the function as indi-
cated in the chapter on the "Shower" function.
• To use the set of jets on the left (that operate simultane-
ously) position the ring nut of the deviator as shown in fig. 7 at
the "dorsal jets" symbol.
A
1
3
5
7
38
2
4
6
38