Zanussi ZTK 123 User Manual page 27

1. To open the door,
push the catch as per
picture. During the
drying cycle or at the
end, it is normal for
water to be present
on the surface of the
condenser insertion.
3. Pull out the con-
denser unit holding it
at the handle .
Important! Do not use pointed objects or
utensils to clean the spaces between the
plates, as this could damage the condenser
and make it permeable. Re-fit the condenser,
turn the red stops upwards and close the door.
Important! Do not use this appliance if the
condenser has not been fitted.
Emptying the water reservoir
Water extracted from the laundry condenses
inside the machine and is collected in a reser-
www.zanussi.com
2. Turn the two red
stops downwards.
4. Clean it with a
brush and rinse it un-
der the shower if
necessary. Also clean
the outside, removing
all fluff. Clean the
rubber seal round the
condenser cabinet
and in the inner part
of the small door with
a damp cloth.
voir. The reservoir must be emptied after each
drying cycle to ensure efficient operation when
the machine is next used. The pilot light
Water Reservoir reminds you this operation.
1. Open the small
door at the lower part
of the cabinet
Cleaning the drum
Caution! Do not use abrasives or steel
wool to clean the drum.
Lime in the water or cleaning agents may
form a barely visible lining on the inside of
the drum. The degree to which the laundry has
been dried is then no longer detected reliably.
The laundry is damper than expected when re-
moved from the appliance.
Use a standard domestic cleaner (e.g. vinegar-
based cleaner) to wipe down the inside of the
drum and drum ribs.
2. Turn the yellow
stop upwards
3. Pull out the reser-
voir
4. Open the small
cover and let water
flow down
5. Close the small
cover and re-insert
correctly the reservoir
6. Push it until it
clicks and turn the
yellow stop down-
wards firmly lock it.
7. Close the small
door and press the
START/PAUSE
button again to allow
the programme to
continue.
27